Jinan QingQi QM50QT-6 Manual page 31

①battery
The battery is located under the footboard. This
battery is sealed type and requires no maintenance such as
fluid level and gravity.
1.Safety
1.1 Strong acid in the fluid can corrupt the skin, eyes
and clothes. Please wear protecting glasses and
rubber gloves when working near the battery or
recharging it.
1.2 If the electrolyte is come into the eyes, wash eyes at
least 15 minutes immediately and go to see the
doctor.
1.3 If drinking it by accident, take much water or milk.
Then drink magnesia milk or vegetal oil.
1.4 Lay it in the place where the children can't reach.
2.How to fill the fluid
● Fill the battery fluid after removing the battery
from the motorcycle.
● Make sure if this electrolyte conforms the desire.
2.1Place the battery erectly, then open the cover.
2.2 Take the electrolyte container out of the plastic bag.
2.3 Take up the electrolyte container upside down and
make the container sprue aim at the battery sprue.
Depress the electrolyte container to lunge the
membrane of the battery sprue. Let the electrolyte flow
into the battery. Check the respective three pipes right and
left. When at least one pipe on each side is emitting
bubble, the normal work begins.
● Do not place the electrolyte container
crosswise, or the fluid may stop flowing.
2.4 Make sure at least one pipe on each side is emitting
bubble. After 20 minutes, if no pipe is emitting bubble,
beat container bottom 2-3 times, then check the two sides
to make sure at least one pipe on each side is emitting
bubble.
● Do not remove the electrolyte container.
● Do not cut off joint by pliers.
2.5 After the electrolyte flowing finishes, beat the bottom
of the electrolyte container again for several times to
make the remainder vent. Then pull out the electrolyte
container slowly.
31