Philips HTS3610 Service Manual page 5

Connect
Position Speakers &
Subwoofer
1 Place centre speaker on or close to the TV.
2 Place subwoofer on the floor.
3 Place front speakers equal distance from the
TV and angle them 45 degree to the listener.
4 Place rear speakers facing the listener, equal
distance on the left and right.
Fix Antennas
1 Connect the FM antenna to the FM socket,
extend the antenna and fix it on the wall.
DVD System (back)
Pr Y
Pb
2 Unfold the AM/ MW loop antenna and fix the
claw into the slot.
3 Push back tab and insert each wire into slot.
DVD System (back)
Pr Y
Pb
MW loop
antenna
Connect Speakers &
Subwoofer to DVD System
Connect the various coloured plugs from the
speakers and subwoofer to the same colour
socket on the rear of DVD system.
Front Front
Speaker Speaker
Centre
(right) Sub-Woofer Speaker (left)
Pr Y
Pb
Rear DVD System (back) Rear
Speaker Speaker
(right) (left)
Connect DVD system to TV
1 Use the supplied black Scart cable to connect
the SCART socket on the rear of the DVD
system and the SCART input socket at the
rear of the TV.
2 Plug in the power cable of the DVD system
to an AC outlet.
Tip To connect other devices
to the DVD system, refer to
the use manual.
Television (back)
SCART IN
SCART IN
DVD System (back)
Y
Pr
Pb
SCART
SCART
Connect Audio from TV
to DVD System (Optional)
Use the red & white audio cables to connect
the red & white TV-IN sockets on the rear of
the DVD system and the red & white AUDIO
OUT sockets on the TV.
Television (back) VIDEO OUT
(CVBS)
AUDIO OUT
VIDEO OUT
(CVBS)
AUDIO IN
Pr Y
Pb
DVD System (back)
Tip Some TVs may not
have an AUDIO OUT jack.
Setup
Insert Batteries in
Remote Control
1 Remove batteries compartment cover.
2 Insert the provided batteries in the remote
control.Take note of where the positive and
negative ends should go.
3 Replace the batteries compartment cover.
Remote Control (back)
Find Correct Viewing Channel
1 Press STANDBY-ON
on the DVD
system's remote control.
2 Press DISC
on the
remote control repeatedly
until 'DISC' appears on the
front panel.
3 Press SETUP
.
4 Switch on the TV.
5 Press '0' on the TV's remote
control, then repeatedly
press the Channel Down
button until you see the
General Setup Page.This is
the correct viewing channel
for the home theatre
system.
Tip In some TVs, to find the
correct viewing channel, you
can keep pressing the AV or
the SELECT buttons. If still
unable to find the correct
viewing channel, check the
connections again or check
your TV's user manual.
6 Press SETUP
to finish.
Tip To make changes to any of the options in
the Setup menus, refer to the user manual.