How To Mount The Ice Maker Kit - Whirlpool IC13B Installation And Operating Instructions Manual

How to Mount the Ice Maker Kit

1 Screw 5 / " ice maker mounting screws into
8
holes provided in
left wall of freezer
section.
• Leave head out
approximately
3
/ " for the slot in
8
the icemaker
hanger to slip over the screws.
• Remove phillips screw (A) if present
and discard.
2 Snap ice maker cover into place onto ice
maker.
• Insert tabs on top
of cover into slots
on top of end of ice
maker.
• Snap bottom of ice
maker ice maker cover into place.
3
Insert wire harness plug into
connector on back wall of freezer
by using a rocking motion until
locking fingers on plug snap
into place.
4
Slip fill tube into self-
positioning fill tube opening
in back of ice maker..
5
Slide ice maker
hangers (A) over
screws.
3 / "
8
3
/ "
8
A
A
Installing Your Ice Maker
Insert remaining mounting
6
screw into bottom of ice
maker, and tighten down all
mounting screws.
7
Raise feeler arm to the
STOP (up)
position until water
connection is complete.
• Ice maker should feel securely mounted.
8
Replace baskets and shelves, and place ice
storage bin directly under ice maker.
NOTE: Check again to make sure the icemaker wire
harness is fully inserted into its outlet.
7