Table of Contents
Advertisement
Troubleshooting
C a u t i o n
8
Troubleshooting
If the Power Status LED and the switch Fault LED are flashing, either the
power supply is not connected to an active AC power source, the power supply
is not properly installed, or a fault condition has been detected on the power
supply.
1.
Verify the power cord is plugged into an active power source and to the
power supply. Make sure these connections are secure. You can verify that
the AC power source is active by plugging a different device into the outlet
and verify that it is receiving power.
2.
If the Power Status LED continues to flash, verify that the fan in the power
supply is working. If it is, you can feel air being blown out of the vent
holes. If it is not, try plugging the power supply into a different outlet,
and/or try a different power cord.
3.
If the previous steps do not resolve the problem, try removing and
reinstalling the power supply.
Make sure the AC power cord is disconnected from the supply before
removing and reinstalling the supply.
If the power source and power cord are OK and this condition persists, the
switch power supply may be faulty. Call your HP-authorized LAN dealer, or
use the electronic support services from ProCurve to get assistance. See the
Customer Support/Warranty booklet supplied with the power supply for more
information.
Customer Support Services
If you are having any trouble with your power supply or switch, Hewlett-
Packard offers support 24 hours a day, seven days a week through the use of
a number of automated electronic services. See the Customer Support/
Warranty booklet that came with your switch or power supply for information
on how to use these services to get technical support. The ProCurve
networking products Web site,
support information.
Additionally, your ProCurve authorized network reseller can also provide you
with assistance, both with services that they offer and with services offered
by ProCurve.
www.procurve.com
also provides up-to-date
Advertisement
Table of Contents
