Using Coff Ee Pods; Programming The Quantity Of Coff Ee - Saeco nina plus bar Operating Instructions Manual

• (Fig.14) - Press:
- button (15) to brew 1 coff ee, or
- button (16) to brew 2 coff ees.
• When the programmed quantity of coff ee has been
obtained, brewing will stop automatically. Remove the
coff ee cups (Fig.15).
• (Fig.16) - Wait a few seconds after brewing, then remove
the pressurized portafi lter and empty the remaining coff ee
grounds.
Note: If a small quantity of water remains in
the portafi lter, this is absolutely normal and is
due to the portafi lter features.
Important note: The fi lter (11) should be kept
clean to guarantee perfect results. Clean daily
after use.
5.2 Using Coff ee Pods
• (Fig.10) - Use a coff ee spoon to remove the fi lter for ground
coff ee (11) from the pressurized portafi lter (10).
• (Fig.7A) - Insert the coff ee pod adapter (13) - with the
convex part facing down - into the pressurized portafi lter
(10).
• (Fig.7B) - Then, insert the pod fi lter (14) into the pressurized
portafi lter (10).
• (Fig.11) - Insert the pressurized portafi lter into the brew
unit (6) from the bottom.
• (Fig.12) - Turn the portafi lter from left to right until it locks
into place. Release the grip from the pressurized portafi lter.
The handle is automatically slightly turned leftwards.
This movement guarantees portafi lter performance.
• (Fig.14) - Preheat the pressurized portafi lter by pressing
the button (16). Water will spill out of the pressurized
portafi lter (this has to be done only for the fi rst coff ee).
• Water dispensing will stop automatically.
• (Fig.16) - Remove the pressurized portafi lter from the
machine by turning it to the left and pour out any water
left.
• (Fig.9B) - Insert the pod into the portafi lter and make sure
the paper of the pod does not overhang the portafi lter.
• (Fig.11) - Insert the pressurized portafi lter into the brew
unit (6) from the bottom.
• (Fig.12) - Turn the portafi lter from left to right until it locks
into place.
• Take one preheated cup and place it under the portafi lter.
Check that it is correctly placed under the coff ee brewing
nozzles.
• (Fig.14) - Press the button (15) for 1 coff ee.
• When the programmed quantity of coff ee has been
obtained, brewing will stop automatically. Remove the
coff ee cups (Fig.15).
• (Fig.16) - Wait a few seconds after brewing, then remove
the portafi lter and dispose of the used pod.
Important note: The fi lter (14) and the adapter
(13) should be kept clean to guarantee perfect
results. Clean daily after use.
5.3 Programming the Quantity of Coff ee
It is possible to preset the quantity of coff ee to be brewed by
pressing the buttons (15) or (16).
The quantity of coff ee can only be programmed
for the button (15) (min. 25cc, max. 180cc).
By pressing the button (16), you will have twice the
quantity programmed by the button (15).
• To start programming, insert coff ee into the portafi lter as
shown in Sections 5.1 and 5.2.
• Place a cup under the brew unit (10).
• (Fig. 14) - Press the coff ee brew button (15) for a few seconds.
After 3 seconds, the machine will start brewing coff ee.
• When the desired quantity of coff ee is in the cup, release the
button (15).
Programming is complete. From now on the machine will
brew:
• The same quantity as the one previously selected by pressing
and releasing the button (15).
• Twice the quantity as the one previously selected by pressing
and releasing the button (16).
• 19 •