Table of Contents
Advertisement
4.3
Connectors
This section describes the internal connectors on the motherboard.
Refer to section "1.4 Rear panel features" for information on the
external (rear panel) connectors.
1 .
1 .
1 .
1 . 1 .
F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y 1 )
F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y 1 )
F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y 1 )
F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y 1 )
F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y 1 )
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the
floppy drive. (Pin 5 is removed to prevent incorrect insertion when
using ribbon cables with pin 5 plug).
NCL-DS1R2 Floppy disk drive connector
2 . 2 .
2 .
H a r d d i s k a c t i v i t y L E D c o n n e c t o r ( 4 - p i n H D L E D 1 )
H a r d d i s k a c t i v i t y L E D c o n n e c t o r ( 4 - p i n H D L E D 1 )
2 .
2 .
H a r d d i s k a c t i v i t y L E D c o n n e c t o r ( 4 - p i n H D L E D 1 )
H a r d d i s k a c t i v i t y L E D c o n n e c t o r ( 4 - p i n H D L E D 1 )
H a r d d i s k a c t i v i t y L E D c o n n e c t o r ( 4 - p i n H D L E D 1 )
This connector supplies power to the hard disk drive activity LED. The
read or write activities of any device connected to an add-on SCSI
card or RAID card cause this LED to light up.
NCL-DS1R2 SCSI/SATA card activity LED connector
A S U S A P 2 4 0 0 R - E 2
A S U S A P 2 4 0 0 R - E 2
A S U S A P 2 4 0 0 R - E 2
A S U S A P 2 4 0 0 R - E 2
A S U S A P 2 4 0 0 R - E 2
FLOPPY1
PIN 1
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
HDLED1
1
4 - 9
4 - 9
4 - 9
4 - 9
4 - 9
Advertisement
Table of Contents
