Philips SCD464 User Manual page 13

Problem
POWER light (A-6, B-9)
does not light.
POWER light (A-6, B-9)
is blinking.
High pitched noise.
Pick-up from another
baby monitor.
LINK light (B-3)
flashing red / LINK
alarm beeps.
Possible cause
Unit not switched on.
AC power adapter (A-3, B-5)
not connected to the
DC 9V — — < < + + power supply
jack (A-2, B-4).
AC power adapter (A-3, B-5)
not connected to the power
supply.
Batteries low.
Batteries low.
Units too close to each other.
Volume set too high.
Both systems are operating
on the same frequency.
Units are out of range.
Interference from another
baby monitor.
Interference from another
FM source.
Troubleshooting
Solution
Press On/Off button (A-1) or
set On/Off switch (B-8) to ON.
Connect AC power adapter
(A-3, B-5) to the DC 9V — — <
power supply jack (A-2, B-4).
Connect AC power adapter (A-3,
B-5) to a wall outlet.
Replace batteries.
Replace batteries.
Move parent unit away from baby
unit (at least 1 metre / 3 feet).
Turn ON/OFF switch /
VOLUME control (B-8) upwards.
Switch channels (A-8, B-7).
Make sure both units are set
to the same position.
Move units closer together.
Switch to a different channel
(A-8, B-7).
Remove other FM source.
EN
< + +
13