Samsung AC***FB4DEH Installation Manual page 22

Setting an indoor unit address and installation option AA
Setting an indoor unit installation option (suitable for the condition of each installation location)
1. Check whether power is supplied or not.
- When the indoor unit is not plugged in, there should be additional power
supply in the indoor unit.
2. The panel(display ) should be connected to an indoor unit to receive option.
3. Set the installation option according to the installation condition of an air
conditioner.
- The default setting of an indoor unit installation option is "02000-100000-
200000-300000".
- Individual control of a remote controller(SEG20) is the function that controls an indoor unit individually when there is
more than one indoor unit.
4. Set the indoor unit option by wireless remote controller.
SEG1
0
SEG7
1 Drain pump
SEG13
2 External control
SEG19
Individual control of
3
a remote controller
▶ 1WAY/2WAY/4WAY MODEL : Drain pump(SEG8) will be set to 'USE + 3minute delay' even if the drain pump is set to 0.
▶ 1 WAY/2WAY/4WAY,DUCT MODEL : Number of hours using filter(SEG18) will be set to '1000hour' even if the SEG18 is set to
exept for 2 or 6.
▶ If you input a number other than 0~4 of the individual control of the indoor unit(SEG20), the indoor is set as "indoor 1".
▶ 4WAY MODEL : Even when the value of Heating setting compensation(SEG21) is set to '0' , it wil be recognized as '5°C' .
22
SEG2 SEG3
2 RESERVED
SEG8 SEG9
RESERVED
SEG14 SEG15
External control
output
SEG20 SEG21
Heating setting
compensation
SEG4
Exterior
Central control
temperature sensor
SEG10 SEG11
RESERVED RESERVED
SEG16 SEG17
S-Plasma ion Buzzer
Indoor Unit
1(L)
F2
2(N) F1
SEG5 SEG6
RESERVED
SEG12
Master / Slave
SEG18
Number of hours
using filter