Samsung AC071RN4PKG Installation Manual
Hide thumbs
Also See for AC071RN4PKG:
- Service manual (200 pages) ,
- Service manual (257 pages) ,
- Installation manual (38 pages)
Related Manuals for Samsung AC071RN4PKG
Summary of Contents for Samsung AC071RN4PKG
- Page 1 Air conditioner Installation manual AC***RN4PKG Thank you for purchasing this Samsung air conditioner. Before operating this unit, please read this manual carefully and retain it for future reference.
-
Page 2: Table Of Contents
Contents Safety Information Safety Information Installation Procedure Step 1 Checking and preparing accessories Step 2 Choosing the installation location Step 3 Optional: Insulating the body of the indoor unit Step 4 Installing the indoor unit Step 5 Purging inert gas from the indoor unit Step 6 Cutting and flaring the pipes Step 7 Connecting the assembly pipes to the refrigerant pipes Step 8 Performing the gas leak test... -
Page 3: Safety Information
Safety Information WARNING CAUTION WARNING General information WARNING Installing the unit WARNING IMPORTANT: When installing the unit, always remember to connect first the refrigerant tubes, then the electrical lines. English... - Page 4 Safety Information Do not install the air conditioner in following places. – – CAUTION Make sure that you earth the cables. Install the circuit breaker. Make sure that the condensed water dripping from the drain hose runs out properly and safely. Power supply line, fuse or circuit Install the power cable and communication cable of the indoor and outdoor unit at least 1m away from the...
-
Page 5: Installation Procedure
Installation Procedure Step 1 Checking and preparing WARNING accessories Insulation pipe Cable-tie Drain hose m (kg) Ceiling-mounted type (A, m2) Installation manual Clamp User manual Installation template Dimension gauge Step 2 Choosing the installation location Installation location requirements – – CAUTION English... - Page 6 Installation Procedure Indoor unit dimensions Category Square panel Circular panel 1050 1000 Front Ceiling opening dimension 960 (950 - 960) Drain hose Refrigerant connector pipe Large+, Large Wire insert hole Drain hose Refrigerant connector pipe Small Wire insert hole ø100 Common Square panel Circular panel...
- Page 7 Spacing requirements Inspection hole Category Recessed installation Exposed installation A : 1500 mm or more Integrated suspended Square panel Circular panel 261 mm Indoor unit (Unit: mm) 10 mm 1050 20 mm 2500 mm or more Inspection hole Refrigerant 1500 mm or pipe more Obstruction...
-
Page 8: Step 3 Optional: Insulating The Body Of The Indoor Unit
Installation Procedure CAUTION NOTE Indoor unit type and models Dimensions Step 4 Installing the indoor unit Step 3 Optional: Insulating the body of the indoor unit NOTE English... - Page 9 Ceiling support Refrigerant pipe Indoor unit Inspection hole display CAUTION Inspection hole Refrigerant pipe CAUTION Indoor unit display Inspection hole Concrete Hole in anchor Insert Hole in plug Pad stopper Suspension bolt (M10) - field supply Bracket English...
-
Page 10: Step 5 Purging Inert Gas From The Indoor Unit
Installation Procedure Step 6 Cutting and flaring the pipes Pipe cutter Ceiling Indoor unit Gauge of dimensions For the recessed installation of the square panel: 11.5 mm Oblique Rough Burr Pipe For the recessed installation of the circular panel: 41.5 mm Step 5 Purging inert gas from the indoor unit R 0.4 to 0.8 mm... -
Page 11: Step 7 Connecting The Assembly Pipes To The Refrigerant Pipes
Outer Diameter (mm) NOTE Damaged Cracked Uneven Inclined Correct Surface Thickness Step 6 Cutting and flaring the pipes Step 7 Connecting the assembly pipes to the refrigerant pipes There are two refrigerant pipes of different diameters : CAUTION Torque Spanner wrench Flare nut Union... -
Page 12: Step 8 Performing The Gas Leak Test
Installation Procedure Step 8 Performing the gas leak test CAUTION CAUTION Insulator Gas side Liquid side Step 9 Insulating the refrigerant pipes Hanger Additional insulation No gap Refrigerant pipe insulation a x 3 NOTE Insulation cover pipe Insulation pipe Indoor unit Be sure to overlap the insulation. -
Page 13: Step 10 Installing The Drain Hose And Drain Pipe
Step 10 Installing the drain hose and Insulation type (heating/cooling) drain pipe Standard Pipe size High humidity Pipe Remarks (Less than 30°C, (mm) (Over 30°C, 85%) 85%) EPDM, NBR (mm) <Geological condition> <Operation purpose condition> Drain socket Metal clamp Drain hose <Building construction condition>... - Page 14 Installation Procedure CAUTION Check that the indoor unit is level with the ceiling by using the leveller. Support pieces Air ventilation 1 to 1.5 m 1/100 or more Ceiling Ceiling Be horizontal 300 mm or less 20 mm or more Indoor unit Band joint Flexible hose...
-
Page 15: Step 11 Performing The Drainage Test
CAUTION Indoor unit Max. 30˚ NOTE 1000 to 1500 mm Full thread bolt hanger Individual Main air vent air vent (must be installed) 200 mm or more 300 to 550 mm Centralized horizontal drain Main drain pipe pipe (more than 1/100 slope) CAUTION Step 11 Performing the drainage test Water leakage... -
Page 16: Step 12 Optional: For The Installation Of The Circular Panel
Installation Procedure CAUTION Step 12 Optional: For the installation of the circular panel Making a circular opening on the ceiling For the painting of the panel English... -
Page 17: Step 13 Optional: Installing Dpm (Digital Packaged Multi)
Step 13 Optional: Installing DPM (Digital Packaged Multi) NOTE Wiring terminals) 1 phase CAUTION Indoor unit Outdoor unit Step 14 Connecting the power and communication cables 1(L) 2(N) CAUTION Communication Indoor power Main power cable cable – – – English... - Page 18 Installation Procedure Wiring terminals) 3 phase Indoor power supply Power supply Max/Min(V) Indoor power cable Indoor unit Communication cable Outdoor unit (Unit: mm) 1(L) 2(N) L1(R) L2(S) L3(T) Communication: M3.5 screw AC power: M4 screw 12.6 Communication Indoor power Main power cable cable NOTE Cable insert...
-
Page 19: Step 15 Optional: Extending The Power Cable
Step 15 Optional: Extending the power cable Method 1 Method 2 Tools Spec Shape Method 1 Method 2 Connection sleeve Connection sleeve Compression dimension CAUTION Method 1 Method 2 Compress it 4 times. Compress it 4 times. Power cable 5 mm 5 mm (Unit: mm) Pre-installed tube for the power cable... -
Page 20: Step 16 Setting The Indoor Unit Addresses And The Installation Options
Installation Procedure Step 16 Setting the indoor unit addresses and the installation options Method 1 Method 2 Insulation tape Insulation tape Common steps for setting the addresses and options 40 mm 35 mm AR-KH00E/AR-KH03E remote control (for 360 cassette only) Contraction tube Entering the Setting the... - Page 21 SEG1 SEG2 SEG3 SEG4 SEG5 SEG6 CAUTION SEG7 SEG8 SEG9 SEG10 SEG11 SEG12 SEG13 SEG14 SEG15 SEG16 SEG17 SEG18 SEG19 SEG20 SEG21 SEG22 SEG23 SEG24 On (SEG1 to SEG12) Off (SEG13 to SEG24) Steps Remote control display English...
- Page 22 Installation Procedure Steps Remote control display English...
- Page 23 Steps Remote control display English...
- Page 24 Installation Procedure Steps Remote control display English...
- Page 25 Steps Remote control display AR-EH03E remote controls [SEG2, SEG3] [SEG4, SEG5] [SEG6, SEG8] [SEG9, SEG10] Entering the Setting the mode for setting option values the options [SEG11, SEG12] [SEG14, SEG15] [SEG16, SEG17] [SEG18, SEG20] [SEG21, SEG22] [SEG23, SEG24] NOTE English...
- Page 26 Installation Procedure SEG1 SEG2 SEG3 SEG4 SEG5 SEG6 CAUTION SEG7 SEG8 SEG9 SEG10 SEG11 SEG12 SEG13 SEG14 SEG15 SEG16 SEG17 SEG18 SEG19 SEG20 SEG21 SEG22 SEG23 SEG24 On (SEG1 to SEG12) Off (SEG13 to SEG24) Steps Remote control display English...
- Page 27 Steps Remote control display English...
- Page 28 Installation Procedure Steps Remote control display English...
- Page 29 Steps Remote control display English...
- Page 30 Installation Procedure Steps Remote control display [SEG2, SEG3] [SEG4, SEG5] [SEG6, SEG8] [SEG9, SEG10] [SEG11, SEG12] [SEG14, SEG15] [SEG16, SEG17] [SEG18, SEG20] [SEG21, SEG22] [SEG23, SEG24] English...
- Page 31 Setting the indoor unit addresses Option No. for an indoor unit address: Common steps for setting the 0AXXXX-1XXXXX-2XXXXX-3XXXXX addresses and options Indoor unit Option SEG1 SEG2 SEG3 SEG4 SEG5 SEG6 Option SEG7 SEG8 SEG9 SEG10 SEG11 SEG12 English...
- Page 32 Installation Procedure CAUTION Indoor unit Common steps for setting the addresses and options Setting the installation options in a batch Option No. for an indoor unit address: 02XXXX-1XXXXX-2XXXXX-3XXXXX Option SEG1 SEG2 SEG3 SEG4 SEG5 SEG6 Option SEG7 SEG8 SEG9 SEG10 SEG11 SEG12 English...
- Page 33 Option SEG13 SEG14 SEG15 SEG16 SEG17 SEG18 Option SEG19 SEG20 SEG21 SEG22 Option SEG23 SEG24 English...
- Page 34 Installation Procedure Condition SEG14 Setting Result External control Level control Indoor 1 Indoor 2 Indoor 3 Indoor 4 SEG23 SOFT OFF HARD OFF Changing the addresses and options individually Common steps for setting the addresses and options Option SEG1 SEG2 SEG3 SEG4 SEG5...
- Page 35 Emergency Temperature Output (ETO) function CAUTION – – – Setting up the ETO Error output port (1, 2) Main indoor unit Communication between External contact indoor and outdoor units interface module (F1 and F2) MIM-B14 Contact input port (5, 6) Sub indoor unit –...
- Page 36 Installation Procedure ETO operation specifications – – – Enable of external Enable of ETO Error port output contact Main indoor unit Enable of entrance Enable of external Operation when outputting Main control contact Sub indoor unit English...
-
Page 37: Appendix
Troubleshooting Indoor unit display indications Condition Ice blue Yellow green Blue English... - Page 38 This appliance is filled with R-32.