Watch Dog Timer Setting - Contec bx200 SERIES User Manual

5. BIOS Setup

Watch Dog Timer Setting

These are settings of the output to the PO2 from watch dog timer for the RAS port.
For the models without the RAS port(s), this setting item is not displayed.
Table 5.8. Watch Dog Timer Setting
Description Choice
WDT Output to PO2
Sets the output to the PO2 of watch dog timer.
When "Enabled", the watch dog timer output is sent to the
PIO2 pin of the RAS connector. Actual value of the output is
subject to the settings of "WDT Power-on State" and "WDT
Time-up State".
WDT Power-on State
This is "On" when the "WDT Output to PO2" is set to
"Enabled". This option sets the status of the output from the
watch dog timer at the power on.
WDT Time-up State
This option is effective when the "WDT Output to PO2" is
"Enabled". Sets the status of the output from the watch dog
timer at the time up of the watch dog.
64
BX-2x0-DCxxxx, BX-2x0D-DCxxxx User's manual