English
CONNECTING WITH CLEANER
By connecting with cleaner (sold separately) through
dust collector and adapter (sold separately), most of
dust can be collected.
(1)
Remove the hexagonal bar wrench from the base.
(2)
Move the base fully forward. (Fig. 7, Fig. 8 on
page 22)
(3)
Connect the dust collector with adapter. (Fig. 14)
(4)
Connect the adapter with the nose of cleaner.
(Fig. 14)
(5)
Insert dust collector into the rear hole of the base
until the hook catches in the notch. (Fig. 15)
(6)
Press the hook to remove the dust collector.
NOTE
Wear the dust mask additionally, if available.
CONCERNING CUTTING OF STAINLESS STEEL
PLATES
CAUTION
In order to prevent blade dislodging, damage or excessive wear on the Plunger,
please make sure to have surface of the base plate attached to the work piece
while sawing.
When cutting stainless steel plates, adjust the unit as described below:
1.
Adjust the speed
Blade
Thickness of material
No. 97
NOTE
Dial scale reading is for reference only. The higher the speed is, the quicker the material is
cut. But the service life of the blade will be reduced in this case. When the speed is too low,
cutting will take longer, although the service life will be prolonged. Make adjustments as
desired.
2.
Set the orbital position to "0"
NOTE
When cutting use cutting fl uid (oil base cutting fl uid) to prolong the blade's service life.
1.5 – 2.5 mm
Base
Notch
Base
Rear hole
Dial Scale
Middle groove position between scales "2" and "3"
24
Adapter
Nose
Dust collector
Cleaner
Fig. 14
Hook
Dust collector
Adapter
Fig. 15
Nose