Outdoor Unit - Panasonic cs-s9pkv Service Manual

10.2 Outdoor Unit

10.2.1 Install the Outdoor Unit

After selecting the best location, start installation to Indoor/Outdoor Unit Installation Diagram.
1 Fix the unit on concrete or rigid frame firmly and horizontally by bolt nut (ø10 mm).
2 When installing at roof, please consider strong wind and earthquake.
Please fasten the installation stand firmly with bolt or nails.
A
10.2.2 Connect the Piping
10.2.2.1 Connecting the Piping to
Indoor
Please make flare after inserting flare nut (locate at
joint portion of tube assembly) onto the copper pipe.
(In case of using long piping)
Connect the piping

Align the center of piping and sufficiently tighten
the flare nut with fingers.

Further tighten the flare nut with torque wrench in
specified torque as stated in the table.
10.2.2.2 Connecting the Piping to
Outdoor
Decide piping length and then cut by using pipe cutter.
Remove burrs from cut edge.
Make flare after inserting the flare nut (locate at valve)
onto the copper pipe.
Align center of piping to valve and then tighten with
torque wrench to the specified torque as stated in the
table.
B
Model
S9***
S12***
S18***, S24***
Do not overtighten, overtightening may cause gas leakage.
Piping size
6.35 mm (1/4")
9.52 mm (3/8")
12.7 mm (1/2")
15.88 mm (5/8")
19.05 mm (3/4")
54
A B C
474 mm 87 mm 18.5 mm
570 mm 105 mm 18.5 mm
613 mm 131 mm 16 mm
Torque
[18 N•m (1.8 kgf.m)]
[42 N•m (4.3 kgf.m)]
[55 N•m (5.6 kgf.m)]
[65 N•m (6.6 kgf.m)]
[100 N•m (10.2 kgf.m)]
D
261 mm
320 mm
360.5 mm