Canon w-e1 Instruction Manual page 77

11: Connection target not found
In the case of [q], is Camera Connect running?

Establish a connection using Camera Connect (p.24).

In the case of [D], is EOS Utility running?

 Start EOS Utility and re-establish the connection (p.29).
Are the camera and the access point set to use the same

encryption key for authentication?
This error occurs if the encryption keys do not match when the

authentication method for encryption is set to [Open system].
The setting is case-sensitive, so check upper- and lower-case
characters. Make sure that the correct encryption key for
authentication is set on the camera (p.47).
12: Connection target not found
Is the power of the target device and access point on?

Turn on the target device and access point, then wait a while. If a

connection still cannot be established, perform the procedures to
establish the connection again.
Is the camera too far from the target device or the antenna of

the access point?
Bring the camera and the target device or the antenna of the

access point closer together.
Responding to Error Messages
77