Zte ZXR10 2900E series Configuration Manual page 231

Chapter 6
Management
Table of Contents
Remote-Access..........................................................................................................6-1
SSH ...........................................................................................................................6-3
Privilege ...................................................................................................................6-11
SNMP ......................................................................................................................6-13
RMON......................................................................................................................6-18
ZGMP ......................................................................................................................6-21
sFlow .......................................................................................................................6-28
Web .........................................................................................................................6-29
M_Button..................................................................................................................6-49
Telnet .......................................................................................................................6-52
6.1 Remote-Access
Remote-Access Overview
Remote-Access is a mechanism for limiting network management users to manage the
switch through Telnet, SSH, SNMP and Web, that is, it is used to restrict the access. This
function is to enhance the security of the network management system.
After this function is enabled, specify a network management user to access the switch
only from a specified IP address, the user cannot access the switch from other IP
addresses. When this function is disabled, the network management user can access the
switch through Telnet, SSH, SNMP and Web from any IP address.
Configuring Remote-Access
The Remote-Access configuration includes the following commands:
Command
zte(cfg)#
zte(cfg)#
nmp | telnet | ssh | web}{permit | deny}]
zte(cfg)#
SJ-20130731155059-002|2013-11-27 (R1.0)
set remote-access {any | specific}
set remote-access ipaddress <A.B.C.D>[<A.B.C.D>][{s
clear remote-access all
6-1
ZTE Proprietary and Confidential
Function
Enables or disables the remote
access control function.
Permits or denies switch access
from a specified IP address
or network segment through
SSH/SNMP/Telnet/Web.
Deletes all IP address
configurations.