Stamina 1110 Owner's Manual page 10

ASSEMBLY INSTRUCTIONS
STEP 8
Insert the PEDAL SHAFT(6) through the tube located on the MAIN FRAME(1). Slide a PEDAL CAP(19)
onto each end of the PEDAL SHAFT(6). Then secure the PEDAL CAPS(19) with BUTTON HEAD
BOLTS(M8x1.25x15mm)(60) and LARGE WASHERS(M8)(83) at both ends of the PEDAL SHAFT(6).
You need to use two Allen Wrenches to tighten the BUTTON HEAD BOLTS(M8x1.25x15mm)(60) at both
ends of the PEDAL SHAFT(6) at the same time.
STEP 9
Install two AAA batteries into the METER(35), the batteries are not included. See page 12 for detailed
battery installation instructions. Insert the METER(35) onto the METER PLATE(36). Connect the SENSOR
WIRES(33) to the connecting wires of the METER(35).
35
33
36
19
60
83
1
19
6
83
60
10