PSR-S770/PSR-S970
■ DISASSEMBLY PROCEDURE
Precautions
* Disassembly or assembly should be performed on a cloth so as not to damage the LCD.
* Install the filament tape and the harness clamp in the same way as they were before removal.
* Notes on Flat Cable
Contacts are visible from the back. Pay attention not to insert and install the
cable to the connector inversely. (Photo 1)
1.
Bottom Board Assembly
(Time required: About 4 minutes)
Remove the twenty-two (22) screws marked [450]. The
bottom board assembly can then be removed. (Fig. 1)
<Bottom view>
<Bottom view>
[420A]
[400]
12
[450]
[410]
2.
Lower Case Assembly
(Time required: About 4 minutes)
Remove the nine (9) screws marked [400], the five (5)
screws marked [410] and the four (4) screws marked
[420A]. The lower case assembly can then be removed.
(Fig. 2)
BOTTOM BOARD ASSEMBLY
Fig. 1
[400]
LOWER CASE ASSEMBLY
Fig. 2
Front Side
Back Side
Photo 1
[450]
[420A]
[410]
[400]