Table of Contents
Advertisement
PSR-S770/PSR-S970
4.■ Other■Inspections
4-1.■ AUX■IN
Take measurement with the Test Program [028: AUX-IN Check] selected.
Check that each terminal output is as shown in the table below when a signal is inputted into AUX IN.
■
INPUT
AUX IN L:
Sine wave (1 kHz, 0 dBu)
AUX IN R:
No input
AUX IN L:
No input
AUX IN R:
Sine wave (1 kHz, 0 dBu)
4-2.■ Noise■Level■Check
1)
Do not connect anything to the [AUX IN] and [MIC/GUITAR INPUT] jacks.
2)
Connect the level meter (using the JIS-C fi lter) to the L/R [PHONES] and L/R [OUTPUT] jacks.
3)
Turn the master volume to the maximum position.
4)
Measure the output voltage and confirm that the measured values are within specification as follows:
<PHONES>
L: -90.0 dBu or less
R: -90.0 dBu or less
<OUTPUT>
L: -90.0 dBu or less
R: -90.0 dBu oe less
4-3.■ MIC/GUITAR■INPUT
1)
Take measurement with the Test Program [030: MIC Check] selected.
2)
Do not connect anything to the [AUX IN] jack.
3)
Connect the level meter (using the JIS-C filter) to the L/R [PHONES]. (33 ohms load)
4)
Turn the master volume to the maximum position.
5)
Set the [MIC GUITAR] switch to "GUITAR" and set the [GAIN] knob to the maximum posision.
6)
Apply a 1kHz sine wave -30dBu to the [MIC/GUITAR INPUT] jack via a 100kW resistor.
7)
Measure the output voltage and confirm that the measured values are within specification as follows:
<PHONES>
L:
+0.9 ± 3 dBu
R:
+0.9 ± 3 dBu
8)
Set the [MIC GUITAR] switch to "MIC."
9)
Measure the output voltage and confirm that the measured values are within specification as follows:
<PHONES>
L:
–15.6 ± 3 dBu
R:
–15.6 ± 3 dBu
10) Set the [GAIN] knob to the minimum posision.
11) Measure the output voltage and confirm that the measured values are within specification as follows:
<PHONES>
L:
–49.1 ± 3 dBu
R:
–49.1 ± 3 dBu
50
PHONES■(33■W■load)
OUTPUT
L
+1.6 ± 2 dBu
-56.0 dBu or less
R
-56.0 dBu or less
+1.6 ± 2 dBu
Hide quick links:
Advertisement
Table of Contents
