Telnet Server Enable; Telnet Server Ipv6 Dscp - H3C S5820 series Command Reference Manual

Default
IPv4 uses the DSCP value 48 for outgoing Telnet packets on a Telnet server.
Views
System view
Default command level
2: System level
Parameters
dscp-value: Specifies a DSCP value in the range of 0 to 63.
Examples
# Set the DSCP value for IPv4 to use for outgoing Telnet packets to 30 on a Telnet server.
<Sysname> system-view
[Sysname] telnet server dscp 30

telnet server enable

Use telnet server enable to enable the Telnet server.
Use undo telnet server enable to disable the Telnet server.
Syntax
telnet server enable
undo telnet server enable
Default
The default is as follows:
In a version prior to R1808P12:
•
If the device has not loaded any configuration file, Telnet service is disabled.
If the device is using the factory defaults, Telnet service is enabled.
• In R1808P12 or later, Telnet service is disabled.
For more information about configuration types, see Fundamentals Configuration Guide.
Views
System view
Default command level
3: Manage level
Examples
# Enable the Telnet server.
<Sysname> system-view
[Sysname] telnet server enable

telnet server ipv6 dscp

Use telnet server ipv6 dscp to set the DSCP value for IPv6 to use for outgoing Telnet packets on a Telnet
server.
50