Wiring Specifications - OSCO LA36 Installation Manual

Hide thumbs

Table Of Contents

Table of Contents

LA36 OPERATOR INSTALLATION GUIDE

1. Select from the chart at the bottom of this page corre-

sponding to the model, voltage and horsepower rating of

your operator.

2. The distance shown on the chart is measured in feet from

the operator to the power source. DO NOT EXCEED THE

MAXIMUM DISTANCE. These calculations have been

based on standard 115V with a 10% drop allowable. If

your supply is under the standard rating, the runs listed

may be longer than what your application will handle, and

you should not run wire too near the upper end of the

chart for the gauge of wire you are using.

3. When large-gauge wire is used, a separate junction box

(not supplied) may be needed for the operator power con-

nection.

WIRING SPECIFICATIONS

USE COPPER WIRE ONLY!

MODEL LA36

r e

r i

n i

l o

s t

s i

a t

e r

n i

e l

l a

4. All control devices are now 24VDC, which can be run con-

siderable distances.

5. Wire run calculations are based on the National Electrical

Code, Article 430 and have been carefully determined

based on motor inrush, brake solenoids, and operator re-

quirements.

6. Connect power in accordance with local codes. The green

ground wire must be properly connected.

7. Wire insulation must be suitable to the application.

8. Control wiring must be run in a separate conduit from power

wiring. Running them together may cause interference and

faulty signals in some accessories.

ACCESSORY WIRING

Volts

24VDC

- 4 -

MODEL LA36

All DC Models

Maximum

Wire

Distance (ft.)

Gauge

0-2000

2-03-4

Table of Contents

Wiring Specifications - OSCO LA36 Installation Manual

WIRING SPECIFICATIONS

Related Manuals for OSCO LA36

Related Content for OSCO LA36

Table of Contents