Preventative Maintenance; Battery Maintenance - OSCO LA36 Installation Manual

Table of Contents

LA36 OPERATOR INSTALLATION GUIDE

GENERAL:

OSCO gate operators are designed for many years of trouble-free operation and, under recommended operating conditions, will

require only minimal maintenance. To ensure that your unit is ready for operation at all times--and to preclude serious damage

or failure--inspect the unit systematically. Proper adjustments and lubrication should be made as recommended.

LUBRICATION:

Motor. Motors have sealed ball bearings and do not require further lubrication. If bearing noise develops after several years of

operation, bearings should be replaced by a motor repair company, or the motor should be replaced if necessary.

Shoulder Bolts. Lubricate the front and back shoulder bolts twice a year with a lithium complex-based grease.

Actuator Cylinder. Wipe down the cylinder with WD40 or similar lubricant.

Power and Limits Cable. Inspect the operator to control box cable for cracks in the insulation, breaks, or other signs of failure.

Check all connection points. Replace if necessary.

ADDITIONAL SIX MONTH PREVENTATIVE MAINTENANCE:

1. Inspect all nuts and bolts for proper tightness and tighten as necessary.

2. Check all reversing devices for proper function. Inspect all contact edges for wear and replace if required. Check photo-eyes

for proper alignment and function.

3. Check current sensing for proper adjustment when finished with inspection and maintenance.

4. Inspect the installation area. Are all the warning signs intact and visible? If they are missing or need replaced, contact

OSCO. Be sure there are no control stations mounted within reach of the gate. Review safety literature with the customer

and advise them to remove any such stations found.

The gel-cell batteries in this operator require no routine maintenance. For assured continued performance, they should be

replaced every year.

If power is to be removed for one week or more, turn power switch off, as this will prevent deep discharging.

Fully charge before use after storage or upon initial installation.

PREVENTATIVE MAINTENANCE

WARNING!

YOU MUST TURN OFF THE POWER SWITCH

LOCATED IN THE LA36 CONTROL BOX BEFORE

SERVICING THE GATE OR GATE OPERATOR!

KEEP CLEAR OF THE GATE DURING OPERATION!

You must inspect the gate for proper operation. The

gate should move easily without binding through its

entire travel. If the gate does bind, adjust or fix as

required. Failure to keep the gate in good working

condition will have adverse effects on the operator.

- 23 -

2-03-4

Table of Contents