Music Share - Midland BTX1 PRO Instruction Manual

Ending a call
There are several ways to end a call:
› Wait for the called person to end the call.
› Press the "Forward" button (you will hear an audio confirmation tone).
› Press "End" button on the mobile phone.
Speed dial
You can store one phone number in the unit memory and use it when needed. You must
first save the number using the "BT UPDATER" Pc software or the smartphone "BT
SET-APP" application. Then when you are in phone mode, just press 7 sec. the "Forward"
button.
Using the MP3 player feature of the mobile phone
The mobile phone, when paired on "Volume +" can be used as stereo MP3 players. The
BTX1 PRO device fully supports the A2DP and AVRCP protocols that enable you to
listen to stereo music and remotely control your mobile phone's MP3 player. You can
even use the buttons on the BTX1 PRO unit to control the following play options: Play,
Pause, Forward and Backward of the songs.
Forward Play/Pausa
Available controls:
› To play/pause music: click on the "Middle" button.
› To skip forward to the next song: press the "Forward" button.
› To skip backwards to the previous song: press the "Back" button.
Priority: the music listening mode has the lowest priority. Therefore, it will always be disabled
when another audio communication come in.
To change the priority behaviour you can use the "BT UPDATER" Pc Software or the
www.midlandeurope.com
Backward
smartphone "BT SET-APP" application.
Attention: It is possible to control A2DP Stereo music only in "Phone Mode"

Music Share

To start sharing your A2DP music with the passenger already paired on the middle button
(maximum distance 10mt), you must press the "Backward" button long (3 sec.) while the
music is playing. The passenger must be either in "Phone" or "Intercom" mode without
any open audio. The passenger can only stop the music share pressing short the middle
button (but cannot control the music). The driver can stop the music sharing just pressing
again the "Backward" button long. With music share active you can not keep open the
Intercom communication.
GPS Navigator
The GPS Navigator can be paired using the "Volume+" or the "Volume-" button.
Volume + button (support for stereo A2DP audio and HFP mono)
Volume - button (support for HFP mono audio also in background)
How to pair the BTX1 PRO to a GPS
In general it is possible to pair the BTX1 PRO to all the GPS for motorbike that support
Bluetooth headset connection.
To pair the BTX1 PRO to a GPS, you must first enter the setup mode:
1. Turn off the unit
2. Press and hold down the "Middle" button about 7 sec., until the Red light is on per-
manently.
3. Now press firmly (3 sec) the "Volume +" or "Volume -" button, the Blue and Red
light will flash.
4. Enable the Bluetooth device search feature on your GPS
5. After some seconds, "Midland BTX1 PRO" will be displayed on your GPS.
6. Follow the pairing procedure of your GPS. If a pin code is requested you must enter
"0000" (four times zero).
7. When successfully paired, the Blue light of the unit will be on for one second and then
the unit will exit the setup mode and switch to the working mode (the Blue light will
start flashing).
23