Toning/Probing with the 1 kHz Tone
Function
The IntelliTone signal from the IT100 toner includes a
1 kHz tone you can trace with an analog probe.
H
The
position on the IT100 probe lets you use the
probe to trace a 1 kHz tone from an analog toner.
Maintenance
Clean the case with a soft cloth dampened with water or
water and a mild soap.
W Caution
To avoid damaging the case, do not use solvents
or abrasive cleansers.
Toning/Probing with the 1 kHz Tone Function
Battery Life and Replacement
The toner and probe batteries last for about 20 hours of
typical use.
Figure 5 shows how to replace the battery in the toner
and probe.
WX Warning
To avoid possible electric shock or personal
injury:
•
Turn off the toner or probe and disconnect all
test leads before replacing the battery.
•
Use only a 9 V battery, properly installed in the
case, to power the toner and probe.
W Caution
To avoid unreliable test results, replace the
battery as soon as the low battery indication
appears. See "Battery Status" on page 5.
11