Table of Contents
Advertisement
Installing the optional LiPo battery
The movements and travels
The centre of gravity
First flight
9910.100_WD_V1
Insert the battery with the connection cable facing to the front.
Before connecting the XT60 connector switch on the transmit-
ter and set the motor stop switch or the throttle stick to the
motor "Off" position. Therefore read the transmitter manual. By
connecting the XT60 connector the receiver will be switched
on. After putting the canopy in place the V-VENTURE is ready
to fly.
The surface travels are already corrected set from the factory
and have the following values. Always measured from the sur-
face edge: Elevator approx. 10 mm both upward and down-
ward, ailerons approx 28 mm upward and 12 mm downward.
The center of gravity in the V-VENTURE is between 70 and 80
mm measured from the wing front edge and is properly set from
the factory, while using the suggested LiPo battery. The center
of gravity can be tested for control by holding the model with
two fingers under the center of gravity under the wing. The
model should then be balanced and leveled.
Fly the already properly prepared model in condition of still or
very low wind, for an unexperienced pilot it would be hard to
control the model in windy conditions. To fly the model is nec-
essary a leveled or lightly inclined in the wind direction free sur-
face. Never fly between buildings or trees. When flying a model
aircraft for the first time, it is advantageous if an experienced
helper stands aside in the model review and the first flights.
Push the model by hand with the motor on in the wind direction,
do not launch it. The proper take off speed will be reached by
a few steps. During the take off the nose of the model should
be lightly (approx. 15°) inclined upward.
A trimming of the model controls particularly after the first take
off is necessary, you can do it through the trim levers beside
and under the controls sticks. Trim the aileron control through
the aileron trim so that the model flies straight on. Trim the ele-
vator control so that while motor is on the model flies lightly
upward and climbs gently.
11 / 16
Advertisement
Table of Contents
