Figure 3- 8: Digitizer Configuration; Figure 3- 9: Digital Acquisition - Sampling And Digitizing; Sampling Process 3 - Tektronix TDS7054 User Manual

Sampling Process
Sampling Modes
TDS7104 and TDS7054 User Manual
CH 1
CH 2
CH 3
CH 4

Figure 3- 8: Digitizer configuration

Acquisition is the process of sampling the analog input signal of an input
channel, converting it into digital data, and assembling it into a waveform
record, which is then stored in acquisition memory. Sampling, then, is the
process that provides a waveform record per trigger event (see Figure 3- -10 on
page 3- -34). The signal parts within the vertical range of the amplifier are
digitized. See Figure 3- -9.
Input signal
Figure 3- 9: Digital acquisition — sampling and digitizing
The oscilloscope acquisition system can process the data as it is acquired,
averaging or enveloping the waveform data to produce enhanced waveform
records. Once the waveform record exists (enhanced or not), you can use the
post-processing capabilities of the oscilloscope to further process that record:
perform measurements, waveform math, and so on. Refer to Keys to Using on
page 3- -22 for a description of the acquisition modes.
Digitizer
Digitizer
Digitizer
Digitizer
Sampled points
Acquiring Waveforms
+5.0 V +5.0 V
0 V 0 V 0 V 0 V
- - 5.0 V - - 5.0 V
Digital values
3- 33