Floor Cables - Health Mate Enrich mate Owner's Manual

step 4: floor cables
1. Plug the female end of the main power cord into the "Inlet" socket on the power supply.
2. There are two additional cables that emerge from the bottom panel at the square hole in the back. The thin cable with the round
metal plug connects to the "DATA" socket on the power supply. The plug and socket are "keyed", so that there is only one way
to plug this connector in. Rotate the locking ring clockwise until the plug is tightly locked in place.
3. Plug the thick cable marked "HEATER" coming out of the bottom panel into any of the four "HEATER" sockets on the face of the
power supply.
4. Set the bench panel onto the bench heater panel and slide it all the way back until it butts up against the back wall and rests on
the wooden support.
8
a. installation & maintenance
healthmatesauna.com