Wittkopp HotelStar 7214 Operating Instructions

Electronic lock

Table of Contents

Download this manual

Operating Instructions

HotelStar 7214

Changing users

1 General instructions

• Please read the operating instructions carefully, before acti-

vating the lock.

• The lock is supplied with the following master code: 1-2-3-4-5-6.

For your security, change the factory code immediately.

• Do not use any personal data like birthdays or telephone numbers as

new code.

• If the time window to enter the new code is exceeded, the system shuts

down. An active code stays valid.

• After 4 consecutive wrong code insertions a blocking time of 1 minute

sets in, which doubles after every following wrong insertion (up to 16

minutes max.).

• Each key press is confirmed acoustically.

• Do not use any force.

• Never open the lock case, otherwise the correct operation is at risk and

warranty will be void.

Press the "C" button while the lock is in standby (not during a code insertion

or programming of the lock).

Red LED illuminated

Green LED illuminated = Electronic lock is locked

= Electronic lock is open

www.carl-wittkopp.com

Table of Contents

Do you have a question about the HotelStar 7214 and is the answer not in the manual?

Page 1 Press the “C“ button while the lock is in standby (not during a code insertion or programming of the lock). Red LED illuminated = Electronic lock is open Green LED illuminated = Electronic lock is locked © Carl Wittkopp GmbH - errors and omissions excepted www.carl-wittkopp.com...
Page 2 HotelStar 7214 Operating Instructions 3 Instructions for the hotel guest 3.1 Locking At any time upon locking a 4-digit user code can be chosen. 1. Close the safe door. Enter a 4-digit user code and confirm with “*“ 4725* e.g.
Page 3 HotelStar 7214 Operating Instructions 4 Instructions for the master 4.1 Locking The electronic lock can only be closed by entering the user code. The master can not close the lock with his code. 4.2 Opening If the safe lock is opened by the master code the active user code is deleted.
Page 4 HotelStar 7214 Operating Instructions 5 Power supply and battery change The lock is supplied by a 9 V alkaline block battery (no rechargeable battery!). When battery charge is running low, signalling tones occur a couple of times after entering the code and the red and the green LED flash alternately.