Connecting To A Wireless Lan (Optional: Np05Lm Series) - NEC ME401X User Manual

Connecting to a Wireless LAN (Optional: NP05LM series)

The USB Wireless LAN Unit also provides a wireless LAN connection. To use a wireless LAN connection, you are
required to assign an IP address to the projector.
Important:
• If you use the projector with the USB Wireless LAN Unit in the area where the use of wireless LAN equipment is
prohibited, remove the USB Wireless LAN Unit from the projector.
• Buy the appropriate USB Wireless LAN Unit for your country or area.
NOTE:
• The green LED on the USB Wireless LAN Unit flashes to show that the USB Wireless LAN Unit is working.
• Your computer's wireless LAN adapter (or unit) must be complied with Wi-Fi (IEEE802.11b/g/n) standard.
Attaching the USB Wireless LAN Unit
NOTE:
• The USB Wireless LAN Unit must be inserted into the USB Wireless LAN Unit port in the correct direction. It cannot be inserted
in the reverse direction. If the USB Wireless LAN Unit is inserted in the reverse direction with excessive force applied, the USB
port may break.
• Before touching the USB Wireless LAN Unit, touch a metallic object (such as a door knob or aluminum window frame) to discharge
the static electricity from your body.
• Always insert or remove the USB Wireless LAN unit when the main power is turned off. Failure to do so may cause projector
malfunction or damage to the USB wireless LAN unit. If the projector will not work correctly, turn off the projector, disconnect
the power cord, and then connect it again.
• The USB port of the projector is common use for the VIERWER. When the USB memory is installed and activate the VIEWER,
you can not utilize wireless LAN.
1. Press the POWER button to turn off the projector and set
it into standby condition, and disconnect the power cord.
2. Slowly insert the USB Wireless LAN Unit into the USB port.
Remove the cap from the USB Wireless LAN Unit, and then
insert it with the surface (side of indicator) facing down. Keep
the cap for later use.
NOTE:
• Do not force to insert the USB Wireless LAN Unit.
• Set the supplied strap onto the strap fixing hole for the measure of
anti-theft and dropping-off.
To remove the USB Wireless LAN Unit, disconnect the power cord
and use the above procedure.
NOTE:
• The green LED on the USB Wireless LAN Unit flashes to show that Wire-
less LAN Unit is working. If the USB Wireless LAN Unit is incorrectly
attached, the blue LED will not flash.
• Do not press the button on the USB Wireless LAN Unit. The button will
not work with this model.
6. Installation and Connections
97
Strap fixing hole
USB