Hooking Up The Legend; Checking Operation - Pentair Pool Products Pressure Side Pool Cleaner Legend II Installation Manual

F. Hooking up the Legend
1. Remove the Pressure Tester from the free end of
the Feeder Hose by unscrewing the Hose Nut.
Left hand thread (reverse), (see illustration
previous page).
2. Place mender nut on Legend
Connect the open end of the Feed Hose to the
®
top of the Legend
the mender nut. The arch of the Feed Hose
should align in the same direction as the Swivel
Mast, there should be no twist in the Feed Hose
after connection. (See illustration below.)
3. Carefully twist lock the Sand & Silt debris bag
onto the top of the Legend
sure there is a Rubber Debris Valve attached to
the top of the Vacuum Tube before locking on the
Sand & Silt bag, (this valve is similar to a check
valve to help keep debris inside the bag when
the water pressure is off).
4
®
II
®
II Swivel Mast.
II Swivel Mast and secure with
® II Vacuum Tube. Make
4. Gently place the Legend
the pool filtration pump.
5. Check to make sure the wheel RPM is between
25-32. See page 5
RPM.
G. Checking Operation
When operating correctly, the Legend
in a random pattern throughout the pool, vacuuming
and sweeping the bottom. The climbing ability of the
®
Legend II is dependent on the pools structure and
water flow coming into the pool. It will perform more
efficiently in pools without sharp angles or curves in
the transition from the floor of the pool to the wall.
®
The Legend II comes with a Twist Lock Pressure
Relief Valve (Wall Fitting). If the Legend
receiving too much water pressure, the Pressure
Relief Valve in the Wall Fitting will release the excess
water pressure.
Approximately every three minutes and 30 seconds
®
the Legend II will go into a back-up mode. The
Back-Up Valve cycle time, while in the back-up mode,
is approximately 30 seconds, pulling the Legend
from problem areas.
The Sweep Hose operates in a gentle sweeping
motion to prevent debris from becoming trapped in
hard to reach corners of the pools.
®
If the Legend II does not travel to all areas of the
pool, turn off the pool filtration pump and make the
necessary adjustments from the instructions on the
next page.
®
II in the pool. Turn on
for instructions on wheel
®
II will travel
®
LEGEND® II INSTALLATION MANUAL
II is
®
II