Volvo 164 Instruction Book page 16

Length and height adjustment,
front passenger's seat
The front passenger's seat can be adjust-
ed forwards-backwards by pressing down
catch C on the outside of the seat. Ver-
tically the seat is adjustable to three dif-
ferent positions. Remove the seat cushion
to get to the bolts in the seating bracket.
Remove the two bolts holding the seating
frame to the seating brackets. Place the
frame in the desired position and refit
the bolts in the suitable holes.
I n connection with this adjustment, it may
be desirable or necessary to adjust the
i nclination angle of the entire seat. This
i s done with the eyelet bolt at the front
under the seat frame. Remove the bolt
which goes through the eyelet screw and
fold the seat backwards. Then release
the lock-nut in the floor of the car and
adjust the eyelet screw to the desired
position. Relock securely the eyelet screw
with the locknut.
On vehicles with a bench-type front seat,
corresponding adjustments can be made
vertically.
The passenger's seat can be used facing
opposite the driving direction in order to
hold a safety seat for a child. This is
done by removing the four bolts holding
the seat frame to the sliding rails. Lift off
the seat, turn it back to front on the
slide rails and retighten the nuts. Note
that the lock fittings should remain on
the right-hand side in order to be able
to lock the seat.
OPERATING INSTRUCTIONS
Headrests
The front seats are provided with adjust-
able headrests. If the headrest is to fulfil
i ts function properly, it is important that it
i s correctly adjusted, that is, it supports
against the head and not only against the
neck. The car is delivered with the head-
rests adjusted to standard height. To ad-
j ust slacken the plastic nuts on the head-
rest retainers. After adjusting lock the
headrest by turning the plastic nuts clock-
wise.
1 5