How To Start; Troubleshooting - Whirlpool WFC7500VW Quick Start Manual

CYCLES
(Continued)
Each cycle has a preset Cycle Time and WASH/RINSE TEMP. The preset settings provide the recommended fabric care for
the selected cycle. See chart.
CYCLE
Clean Washer
Do not place clothing in the washer when using this cycle. See "Washer Care" in
the Use and Care Guide.
Drain/Spin
Use this cycle to drain your washer or to drain and spin your wash load.
Rinse/Spin
Use this cycle for loads that need rinsing only. Add fabric softener
to a load using the fabric softener dispenser, if desired.
Heavy Duty
To wash loads of sturdy, colorfast fabrics and heavily soiled garments.
Casual
Use this cycle for normally soiled permanent press blends and synthetic fabrics.
*The cycle times vary automatically based on your water pressure, water temperature, detergent, and clothes load.
The cycle time will be extended if oversudsing occurs or the load is unbalanced.
NOTE: To power down the washer manually after the wash cycle is complete, switch knob to Off position.

How to START

• Place sorted laundry in washer. Close washer door
by pushing it firmly until the lock clicks.
• Open dispenser drawer and add laundry products to the
detergent, bleach or fabric softener compartments. Use only
HE High Efficiency detergent.
• Close drawer slowly to avoid spills.
• Turn on the washer by turning the cycle selector and
selecting one of the cycles. The indicator light for the
selected cycle will illuminate.
CANCEL/DRAIN - How to RESTART
• Press CANCEL/DRAIN once.
NOTE: After a cycle is complete, or if you press and hold
CANCEL/DRAIN for 3 seconds, it will take approximately
1 minute for the Door Lock to unlock, allowing you to
open the washer door.
NOTE: To protect your garments, not all options can be selected with all wash cycles.
NOTE: Between wash cycles, it is important to let the washer interior air dry by keeping the door open.

TROUBLESHOOTING

Noise and vibration
• Make sure all four feet are stable and resting on the floor. Then
check that the washer is perfectly level (use a level).
• When you are pushing on the edges of the washing machine top
plate, the machine should not move front to back, side to side, or
diagonally.
IMPORTANT: If the feet are not on the floor, if the washer is
not level, or moves when you are pushing on the top edges of the
washing machine top plate, see the "Installation Instructions" in the
Use and Care Guide.
Before you call service...check for the following.
ESTIMATED
TIME*(HR:MIN)
1:15
0:18
0:24
1:10
0:45
• Select the desired OPTIONS. Not all Options are available with
all cycles. See "Options and Modifiers."
• Press and hold START (for approximately 3 seconds)
to begin.
• To add a garment after a cycle has been started, you must first
press and hold CANCEL/DRAIN for 3 seconds.
NOTE: It will take 1 minute for the Door Lock to unlock. Add
garment, close door, select desired cycle, and press and hold
START for 3 seconds.
• After the door has unlocked, select a new cycle, options or
modifiers. Press and hold START (for approximately 3 seconds)
to restart the washer.
Estimate Time Remaining display (Long Cycle Times)
The cycle times vary automatically based on your clothes load.
The cycle time will be extended if oversudsing occurs or the load is
unbalanced.
Excessive suds
When excessive suds are detected, a suds routine automatically
starts. This routine removes extra suds and assures proper rinsing of
your garments. To avoid excessive sudsing, use only HE detergent.
See the Use and Care Guide for complete details.
WASH SPIN
TEMP SPEED
Hot High
N/A High
Cold High
Warm High
Warm Low