Applying The Cuff - HoMedics BPA-150 User Manual

APPLYING THE CUFF

1. If the cuff is not assembled, pass the end of the
cuff furthest away from the tubing through the
metal D-ring in order to form a loop.
End of cuff
D-ring
2. Plug the cuff tube into the left side of the unit.
Insert plug here
15
3. Remove tight fitting clothing from around your
upper left arm.
4. Position cuff edge 0.8-1.2
inches (2-3cm) above elbow.
5. Center tube over middle of arm.
6. Pull the end of the cuff so that it tightens
evenly around your arm.
Press the hook
and loop material together to secure.
Allow room for 2 fingers to fit between
the cuff and your arm.
7. Lay your arm on a table (palm upward) so the cuff is
at the same height as your heart. Make sure the
tube is not kinked.
16