Advertisement
Bench Quick Start
The goal of this procedure is to perform a configuration of the SVi1000 up to running Find Stops
and Autotune on a bench. Additionally, this document also provides guidance on when to run
signatures and produce associated reports. This procedure uses GE's ValVue* 3 software
(ver. 3.20 or later) and the SVi1000* DTM (ver. 2.20.0 or later).
WARNING
This procedure consists of the following major steps:
"1. Physical Setup" on page 4
"2. Software Install and Configuration" on page 5
"3. Perform Setup Wizard" on page 10
"4. Save Settings and Device Baseline" on page 12
© 2016 General Electric Company. All rights reserved.
Changing the Application to Normal mode may move the valve. It
may be dangerous if someone is still working with the valve.
Masoneilan SVi1000 Bench Quick Start Manual
| 3
=
Advertisement
