Table of Contents
Advertisement
4.4 Caution!
* Do Not print without inked ribbon or paper, since this
leads to rapid printhead needle wear- out.
* Do Not move the printhead manually.
* Avoid mechanical shocks.
* Before starting to print, check that the inked ribbon
cartridge is correctly installed, the paper is loaded in the
proper position and the printer's upper swiveling part is
locked to the lower one.
* If the printer has worked for some time, avoid touching
the printhead: it can be very hot. It is advisable to wait a
few minutes before attempting to replace the inked rib-
bon cartridge.
* Once the printer has been turned off, wait at least 10
seconds before turning it on again; this allows the inter-
nal reset circuitry to work properly.
* Do Not open the printer when it is operating.
NOTICE
Turn the computer on before the printer and turn the
printer off before the computer. This is only to avoid
dummy data to be sent by the computer printer du-
ring the on/off sequence.
DCA
Intertel
DCA
Intertel
12
NOTE:
The small size of the printhead did not allow for a
headpaper spacing adjustment device to be used in
single-copy or multi copy printing. Therefore, when
multi-copy printing is performed with a freshly in-
stalled inked ribbon cartridge, the first printed pages
may have some ribbon marks.
4.5 Self Test
The printer is able to perform an internal self-check routi-
ne followed by a self-test printout.
To execute this procedure, simply keep the LINE feed
push-button pressed while the printer is powered up. The
test procedure prints a first page with general information
about the MP-2005 and a second page of fonts.
CAUTION
DO NOT SELF TEST WITHOUT INKRIBBON OR PAPER.
DCA
Intertel
V1.1
V1.1
DCA
Intertel
13
V1.1
Advertisement
Table of Contents
