Table of Contents
Advertisement
5.6 Inked Ribbon Cartridge Installation and
Replacement
Cartridge installation/replacement procedure:
●
Turn the printer off.
●
Remove used cartridge by unlocking bottom latch
and then rotating cartridge body upwards as shown
by arrow D.
●
Place ribbon extender on both studs B until it locks
down, paying attention to the ribbon not
disengaging from the extender itself.
●
Gently move the cartridge body along the printing
axis and seat it down on its holder C; the ribbon
should be made to enter partly in the gap between
the steel-wire ribbon holder and the printhead
nose.
●
Stretch the inked ribbon by turning knob A
counter-clockwise. Turn the printer on without
loading any paper; make sure that after the
switch-on side movement of the printhead, the
ribbon is properly positioned under printhead's
nose.
DCA
Intertel
DCA
Intertel
20
DCA
Intertel
V1.1
V1.1
DCA
Intertel
21
V1.1
Advertisement
Table of Contents
