Table of Contents
Advertisement
4.3 Printer Setup
The MP-2005 can be configured by using the DIP-swit-
ches as shown in Fig. 1. The function of the DIP-switches
is depicted in Table 1.
TABLE 1 - DIP SWITCHES
Dip Switch
Function
SW 1-1
Baud rate (see Table 2)
SW 1-2
Baud rate (see Table 2)
SW 1-3
for serial interface:
ON=XON/XOFF mode
OFF=DTR/DSR mode
SW 1-4
Character set
SW 1-5
Character set
SW 1-6
Character set
SW 1-7
CRLF mode: ON
SW 1-8
STAND-BY mode: ON
NOTE: Standard factory setting: SW 4,5,6, ON.
DCA
Intertel
= enabled
OFF = disabled
= enabled
OFF = disabled
DCA
Intertel
10
TABLE 2 - BAUD RATE SELECTION
Baud Rate
SW 1-1
1200
ON
2400
OFF
4800
ON
9600
OFF
CRLF mode = ON means that after every CR character
(carriage return) sent by the host, the printer automati-
cally performs a LF (Line Feed)
operation.
STAND-BY mode = ON means that after a certain pre-set
inactivity period, the printer goes to stand-by mode (re-
duced power drain).
If DIP-switch setting is switched ON while the printer is
on, the new configuration will come into effect only after
a subsequent printer turn-off and turn-on cycle.
DCA
Intertel
V1.1
V1.1
SW 1-2
ON
ON
OFF
OFF
DCA
Intertel
11
V1.1
Advertisement
Table of Contents
