TuffStuff AP-2LPS Standart Assembly Instructions Manual page 3

40
FIG. 1
Using a rubber mallet, insert two Plastic End Caps 2 X 3
(#40) onto the tube-ends of the
Stabilizer Support (#2)
to the
above, and secure it into place using two Hex Head Cap Screws 1/2-
13 X 4 1/4 (#31), four Flat Washers SAE 1/2" (#24) and two Nylon
Insert Jam Lock Nuts 1/2-13 (#37).
Note: Refer to the Exploded View Diagram on page 8 for
further clarifi cation of this assembly.
3
FIG. 3 Fulcrum (#3)
Next, affi x the
Frame (#1)
and secure it into place using one Hex Head Cap Screw
1/2-13 X 5 1/2 (#32), two Flat Washers SAE 1/2" (#24) and one Nylon
Insert Jam Lock Nut 1/2-13 (#39). Next, affi x the
(#4) Main Frame
to the bracket of the
above, and secure it into place using one Hex Head Cap Screw 1/2-13
X 5 1/2 (#32), two Flat Washers SAE 1/2" (#24) and one Nylon Insert
Jam Lock Nut 1/2-13 (#39).
AP-2LPS_AP-2LPD Leg Press Option
2
40
1
Main Frame (#1). Next, attach the
Main Frame (#1), in the position shown
4
1
to the bracket of the
Fulcrum w/Brackets
(#1), in the position as shown
44
FIG. 2
Insert a Pulley 3/8 X 4 1/2 (#15-Labeled G5) into the pulley
bracket of the
one Hex Head Cap Screw 3/8-16 X 1 3/4 (#28) and one Split Lock
Washer 3/8" (#46). Next attach a Rubber Bumper 3/8 X 2 1/2 (#44) to
Main Frame (#1)
the
Screw 3/8-16 X 1 1/2 (#26) and one Steel Bumper Washer 3/8" (#48).
Main FIG. 4
Attach the
(#3) Fulcrum w/Brackets (#4)
and the
and secure it into place using two Hex Head Cap Screws 1/2-13 X 5
1/2 (#32), four Flat Washers SAE 1/2" (#24) and two Nylon Insert Jam
Lock Nuts 1/2-13 (#39).
Assembly Instructions
G5
1
Stabilizer Support (#2)
and secure it into place using
and secure it into place using one Hex Head Cap
3
Foot Plate Bracket (#5)
in the position shown above,
2
5
4
Fulcrum
to, both, the
2