Kenmore 106.8955 Series Use & Care Manual page 12

3. Remove the door from the hinges and replace the top hinge
pin.
4. Remove the screw and door stop at corner A. Remove the
screw and end cap at corner C. Place the door stop at
corner C, and tighten screw. Place the end cap at corner A,
and tighten screw.
5. Remove the screw and door stop at corner D. Remove the
screw and end cap at corner B. Place the door stop at
corner B, and tighten screw. Place the end cap at corner D,
and tighten screw.
A B A B
0
D C D C
A. Top corner open [no end cap) C. Beginning bottom corner end cap
B. Beginning top corner end cap D. Bottom corner open [no end cap]
6. Depending on your model, the brand badge for the front
door of your ice maker may be in the package with the Use
and Care Guide. Fasten the brand badge to the door.
7. Set the door aside.
Reverse Hinges
1. Unscrew and remove the top hinge. Replace the screws in
the empty hinge holes.
2. Remove the screws from the bottom of the opposite side of
the ice maker cabinet. Turn the top hinge upside down so
that the hinge pin points up. Place the hinge on the bottom
opposite side of the ice maker and tighten screws.
3. Remove the "old" bottom hinge screws and hinge. Replace
the screws in the empty hinge holes.
4. Remove the screws from the top of the opposite side of the
ice maker cabinet. Turn the hinge upside down so that the
hinge pin points down. Place the hinge on the top opposite
side of the ice maker and tighten the screws.
5. Remove the top hinge pin.
Replace Door
1. Place the door on the bottom hinge pin.
2. Align the door with the top hinge hole and replace the top
hinge pin.
3. Replace the handle and handle screws.
Replace Door Wrap (on some models)
1. Place the door wrap flange onto the door top and ensure
that it fits correctly.
2. Rotate the door wrap downward until it covers the door
surface completely.
3. Install the 2 hex-head screws into the bottom of the door.
1.
2.
3.
Reverse Door Catch
Remove the white decorative screws from the opposite side
of the door and set aside.
Remove the screws from the magnetic door catch and
replace it on the opposite side of the door.
0
i
Install the white decorative screws on the opposite side of
the door.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
4. Plug into a grounded 3 prong outlet.
12