Advertisement
Simply touch the Sensor Start Pad and let the
Touching the Delay Pad can postpone or interrupt
dishwasher select the cycle needed to clean the
any cycle from 10 minutes to 12 hours.
dJshload. The indicator on the Sensor Start Pad
will light and a tone will sound when the Sensor
To set a delay, first touch Sensor Start Pad or
Start Pad is touched. WASH, wash droplets, an
select any of the option pads. Then, quickly touch
estimated cycle time and MIN (minutes) will
and hold the Delay Pad untilthe desired amount
appear in the Display.
of delay time appears in the Display.
When
touched, the indicator on the Pad will light and a
By using a variety of sensors the dishwasher will
tone will sound. DELAY and 10 MIN will appear in
judge the water temperature, soil level and
the Display.
detergent, as well as the wash arm speed and
rotation.
It then develops an optimum cycle
As you hold the Delay Pad, the time will increase
based on the information gathered,
by 10 minute increments until 30 minutes is
reached. It will then increase to 60 minutes and
Continuouslythroughoutthecyclethedishwasher
continue to increase in one hour increments until
will check the conditions. You may nQtice the
12 hours is reached.
The dishwasher will
time in the Display change (either up or down)
automatically start as soon as the delay time ends.
as the dishwasher ad!usts to the conditions.
DELAY will remain in the Display until the time has
This is normal,
counted down.
The cycle selected may range from 52 minutes
To cancel the delay time, touch the Delay Pad
using 5 gallons of water for prerinsed or lightly
again. The indicator light will go out and the cycle
soiled loads to 110 minutes using 11 gallons of
will start immediately.
water for loads with heavy or dried soils.
Note: If delay is chosen without first selecting a
The Display will also show the drying option last
cycle and options, the dishwasher will select the
selected. It is not necessary to reselect it each
last wash cycle used in the delay mode.
time.
However, you may choose a different
option. See page 9 for drying options.
This feature can also be used to temporarily
interrupt a cycle. The cycle will resume from the
point of interruption when the delay time runs out
or when the Delay Pad is touched again.
8
Advertisement
