Advertisement
4. Place door panel(s) (notched side up) behind
the metal trim at the bottom of the door. Bow
CAUTION: To protect against rupture of fill valve,
the panels so they fit behind the control panel
BE SURE the water lines leading to the dish-
at the top.
washer, are well protected against freezing.
5. Slide the panel(s) under the side metal trim
which was not removed. To do this, it will be
1. Run dishwasher through a cycle using deter-
necessary to compress the backing behind
gent. if an odor remains, repeat using baking
the colored panel(s).
soda in the dispenser cup or adding 1/4cupof
6. Reinstall the side trim which was removed
chlorine bleach in the bottom of the tub. Clean
earlier. Align the holes and replace the three
the bottom edge of the door and front lip of the
screws.
tub with a baking soda and water solution.
2. Turn the water supply off and set the dish- Lower Panel - Most Models
washerto drain (select Rinse & Hold cycle). 1. The loweraccesspanelisheld byfourscrews
Once Rinse & Hold is completed, open the
(two above the panel and two below). With
door and returnTimer to Off.
these removed,the panel may be removedto
3. Disconnect the electrical supply,
make it easy to change panel colors.
4. Place a pan underthe drain outlet. Disconnect 2. With the lower access panel removed, remove
the flexible tubing from the pump and drain the
the four screws along the bottom of panel and
water into pan by pushing down on drain arm
remove the trim which holds the panels. Once
lever. Reconnect hose and secure clamp,
the desired panel is facing out, replace the
5. Prop the door open.
trim, and reinstall the panel to the dishwasher.
To restore service, turn on the electricity and
Use care when changing panels to be certain you
water supply. Select a wash cycle and let the
arenotinjuredonsharpedgesandthatthepanels
dishwasher complete the cycle. Check connec-
tions to make sure they are water tight,
are not damaged. If you have any questions
concerning changing panels or wish to purchase
a different color panel, contact your local Jenn-Air
dealer.
Your Jenn-Air dishwasher comes with reversible
panel inserts which are pre-assembled at the
factory. This enables you to select the color you
want beforeyour dishwasher is installedor choose
another color at a later date.
To Change Panels
Door Panel
1. Remove three screws holding the side trim
stripon oneside ofthe door. Take noteof how
the trim comes off.
2. Graspingthe lower part of the door panel(s),
bow panel(s) outcarefully at the bottomwhile
sliding panel(s) far enough to clear the flange
on the trim strip which was not removed and
remove panel(s).
3. Arrange panel so the desired color is facing
out.
13
Advertisement
