Tunstall THE VIBBY Installation Manual page 18

Programming the Vibby to the Lifeline home unit
Press and hold the cancel key on the Lifeline until a bleep is heard,
release the cancel key. The Red Help button should be flashing
slowly and the unit may announce 'programming mode'.
Press and hold the green cancel key again until a bleep is heard then
release it. The red Help button on the unit should be flashing rapidly
and the unit may announce 'registration mode'.
Press the help button on the Vibby, the Lifeline should acknowledge
it has been programmed by a high pitched bleep or a spoken
message.
Press the green cancel key on the Lifeline to exit programming
mode.
Test the Vibby by pressing the help button on the unit and ensure a
call is raised on the Lifeline.
Test the fall detector part of the Vibby by utilising Demo Mode (page
10)
Page 18 of 24
V3.6