Table of Contents
Advertisement
4.3. Command Set
The commands are as follows
Item
Syntax
1.
Connecting
AAddr<CR>
address
2. Baud rate
BBR[D]<CR>
3. COM port
CCOMPort<CR>
4. PIN code
EPIN<CR>
5. Flow control
FFC[D]<CR>
6. Search timer
GTO<CR>
7. Max number
HNO<CR>
of search
8. Search device
ITO,NO[L]<CR>
9.
Discovery
JE/D<CR>
mode
10. Low Power
KE/D<CR>
Mode
1
If you push the RST button, the COM port of HPS-120 will be stored the factory settings.
2
If you change a factory setting for baud rate, you have to remember it.
3
If you change a factory setting for flow control, you have to remember it.
4
This is a flow control between HPS-120 and DTE (will not be passed it over the air).
5
This is a flow control between DTE (will be passed it over the air).
1
:
Description
Set
a
remote
address
for
connection.
Change the baud rate.
D
(option):
factory setting
Change a request serial port.
Authentication Off: hit <Enter>
Authentication On: Type up to 11
characters
Set the Flow control.
D
(option):
factory setting
Set a search timeout.
TO (timeout): ASCII '0' ~ "999"
Set the max number of search.
NO: ASCII '0' ~ "999"
Execute searching devices.
TO: ASCII '0' ~ "999"
NO: ASCII '0' ~ "999"
L (option): Display a long form.
Set the discovery mode.
'E': Enable
'D': Disable
Set the low power mode.
'E': Enable
'D': Disable
Remarks
device
A
local
a
wireless
BD_ADDR always need to
be difference.
Baud Rate (BR) - 0: 1200,
Change
a
1: 2400, 2: 4800, 3: 9600,
2
.
4: 19200, 5: 38400, 6:
57600, 7: 115200
COMPort: '1' ~ '7'
Only valid in connection mode 2.
Paired
have a same PIN code.
FC - 0: None
Change
a
1: Hardware
3
.
2: DTR/DSR
Connection mode 3 only.
Default: 10 sec.
Connection mode 3 only.
Default: 10
Connection mode 3 only.
',': ASCII 0x2C
Connection mode 1 only.
Default: Enable
Default: Disable
and
remote
adapters
should
4
5
9
Advertisement
Table of Contents
