Table of Contents
Advertisement
4. Usage
1
You can change the configuration of HPS-120 using Hyper Terminal
.
4.1. Hyper Terminal Settings
Baud Rate: 9600 bps / Data Bit: 8 / Parity Bit: None / Stop Bit: 1 / Flow Control: None /
Emulation: VT100
4.2. Configuration
4.2.1. Starting Configuration
Step 1: Plug a HPS-120 into a COM port of PC. And Power it on.
Step 2: Open a Hyper Terminal and set it up.
Step 3: Push the RST button on HPS-120. If you enter the configuration mode successfully, LNK
LED will be flashing every second.
Step 4: Hit the <Enter> key, 5 second later.
Step 5: Change the configuration of HPS-120 with commands, if necessary.
4.2.2. Usage Printing
If you are in the configuration mode, type "?<Enter>" for listing of commands. If you want to
know the usage of a command, type "?[command]<Enter>". All commands and parameters are
case sensitive. And you cannot use a <Backspace>.
4.2.3. After Configuration
After finishing the configuration, you have to execute a command "X" to apply changes.
1
This manual is required the software version 2.0 or above.
8
Advertisement
Table of Contents
