Status Led; Reset Button; Entering The Configuration Mode; Exiting The Configuration Mode - HandyWave HPS-120 User Manual

2.4. Status LED

There are two LED on HPS-120.

OPR (Red): When HPS-120 is supplied the power, it is turned on or flashed.

LNK (Green): When a wireless link is on, it is turned on. If HPS-120 is in the
configuration mode, it will be flashing every second.

2.5. Reset Button

The RST button has the following functions.

Enter / Exit the configuration mode

Restore the factory settings

Disconnect and reconnect a wireless connection.

2.5.1. Entering the Configuration Mode

When the LNK LED is OFF, push the RST button. When the LNK LED is ON, you have to push
the RST button twice to enter the configuration mode. If you enter the configuration mode
successfully, LNK LED will be flashing every second. And HPS-120 COM port will be stored the
factory settings.

2.5.2. Exiting the Configuration Mode

You can have two options to exit the configuration mode.
Exit the configuration mode by software: Type "X".
Exit the configuration mode by the RST button: Push the RST button.

2.5.3. Re-connection

When the LNK LED is on, you can push the RST button to disconnect and reconnect a wireless
link.
1
If you push the RST button, the COM port of HPS-120 will be stored the factory settings.
1
6