Introduction; Safety Responsibilities And Liability; Replacement Parts - SLS Audio LS6500 LINE ARRAY Assembly Manual

Introduction

SLS line array rigging is designed to provide a quick method of flying and shaping line arrays. This Guide
serves as an overview and provides useful hints regarding array construction. Please read in its entirety before
assembling any rigging.

Safety Responsibilities and Liability

All information in this guide is meant only for the purpose of rigging below the SLS supplied Rigging
Frame. All other rigging is considered part of the venue and/or end-user supplied equipment and is not
addressed in this guide. SLS assumes that a working knowledge of accepted rigging practices and safety will
be applied to all rigging materials and practices employed. This guide is not a comprehensive source for
rigging in general. The user must assume all responsibility for the appropriate use of SLS supplied rigging
hardware and follow at a minimum all applicable laws and regulations in force for each venue.
The weakest component determines the safety of the entire rigging assembly. Prior to flying the array, always
inspect all hardware components for wear, deformations, corrosion and missing or damaged parts. Also
inspect the venue attachment points for wear and confirm that the points are suitably load rated for the
suspended array.
No information contained in this guide is intended as a warranty on the part of SLS. Anyone using this
information assumes all liability arising from it's use. Product abuse, use of the product not in accordance
with SLS instructions or use in an application which the product has not been designed for is not covered
under any SLS warranty nor is SLS liable for any loss or damage.
Users in other countries should not assume that local regulations are based upon North American practices.
Users should consult with local regulatory authorities for specific codes and/or guidelines.

Replacement Parts

All defective components should be replaced with an SLS approved part. Contact the factory directly at
(417) 883-4549 to obtain approved replacement parts. SLS is not responsible for problems caused by using
non SLS supplied parts for the SLS supplied portion of the rigging.
LS6500 Assembly Guide