Enersol Pool Panel Installation Manual page 10

Table of Contents

Advertisement

Enersol Pool Panel Installation Guide
d)
Plumbing Layout:
Cool feed from pool (water sensor)
filter
manual or automatic valve
(flow regulator)
solar panels (panel sensor)
return from panels (check valve)
salt generator/chlorinator
The recommended 1.5" or 2" PVC pipes are
e)
attached to the roof and side of the house
with plastic clamps and secured with lag
bolts and roof sealant
f)
Be sure to measure and dry fit all pieces to
ensure a proper and neat fit around all eaves
troughs, then cement (using grey heavy-
bodied PVC cement) the connections and
assemble. The pipes should be secure,
straight, even and close to the house.
g)
At any low point in the plumbing use a tee
and end cap. This will allow for drainage.
pump
ball valve
auxiliary heater
return to pool
At any low points in plumbing, use a
tee and end cap to allow for drainage
during winter months
SYSTEM REGULATION OPTIONS
6 - A valve is necessary to divert
the water to the panels.
a)
A 3-PORT MANUAL VALVE can be used; it
must be turned on and off manually when
the temperature fluctuates during the day to
get the most out of the sun, and must be
turned off at night. The valve is installed in
the feed line from the pool, with the water
coming into the inlet opening. The handle
can then be turned to divert the water to the
panels on sunny days or directly to the pool,
when not using the panels. Remember that
the water flows in the direction that the free
part of the handle is pointing, and the
Indicator points to the closed side.
If manual valve is left "ON" for long
periods of cold weather or at night
pool will lose heat
10 |
P a g e

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Pool Panel and is the answer not in the manual?

Table of Contents