GE gdf520pgjbb Installation Instructions Manual page 2

Installation Preparation
PARTS SUPPLIED
IN INSTALLATION PACKAGE:
• Junction box cover and #10 hex-head screw
• Hose clamp
• Drain hose (approximately 58" long)
• Drain hose hanger
• 2 #8-18 hex head screws to secure brackets to washer tub frame
• 2 Plug buttons
• Toekick (pre-installed on some models)
• 2 side trim pieces (some models)
• 2 mounting brackets for wood countertops or side cabinets
• 2 #8-18 x 5/8" Phillips special head screws, to secure dishwasher
to underside of countertop or to side cabinets
• Insulation pieces (some models)
• Literature, samples and/or coupons
MATERIALS YOU WILL NEED:
•
(including gasket) - with opposite end sized to fit
Hot Water Line
• Thread seal tape
• UL-listed wire nuts (3)
• Masking Tape
Materials Needed for
New Installations:
• Air gap for drain hose, if required
• Waste tee for house plumbing, if applicable
• Electrical cable or power cord kits WXO9X70910
(5' 5" long) or WX09X70911 (7' 11" long) only
• Screw-type hose clamps
• Strain relief for electrical connection
• Hand shut-off valve (recommended)
• Hot water line–3/8" minimum, copper tubing
(including ferrule, compression nut) or
GE Part # WX28X326, flexible braided hose
• WD24X10065 drain hose (12' long), if needed
TOOLS YOU WILL NEED:
• Phillips-head screwdriver
• 1/4" and 5/16" nutdriver
• 6" Adjustable wrench
• Level
• Carpenter's square
• Measuring tape
• Safety glasses
• Flashlight
•
• 15/16" socket (optional for skid removal)
• Gloves
• Pliers
For New Installations Only:
• Tubing cutter
• Drill
• 1-1/2" Hole saw
2
Insulation
Thread
GHT 90° Elbow
Seal Tape
(if applicable)
Hand
Waste Tee
Valve
Hose Clamps
Air Gap
1/4" and 5/16"
Phillips-Head
Nutdriver
Screwdriver
15/16" Socket
Flashlight
Gloves
Bucket
#8 Hex-Head
#10
Mounting
Hex-Head
Bracket
Junction
Screws
Box Screw
1/2" long
Toekick
Drain Hose Hanger
Junction
Box Cover
Side Trim Pieces
(on some models)
Wire Nuts (3)
Electrical Cable
(or Power Cord, if applicable)
Strain Relief
Level
Pliers
Tubing Cutter
6"
Adjustable
Wrench
Safety Glasses
Hole Saw Set
Hose
Drain Hose
Clamp
Plug Buttons
#8 Phillips
Special
Head Screws
Mounting
5/8" long
Brackets
Masking Tape
(if applicable)
Hot Water Line
Coupler for
Optional
optional drain
12' Drain Hose
hose
Carpenter's
Square
Measuring Tape
Drill and Bits