Mitsubishi 4g63 Service Manual page 65

CAUTION
• If the tightening angle is less than 90°, ade-
quate tightness could not be assured.
• If the tightening angle exceeds 100°, loosen
the bolt completely and then perform the
tightening again beginning with the first step.
7. Turn clockwise the bolts 90° to 100° in the
indicated tightening sequence to bring the mark
on each bolt head into alignment with that on the
bearing cap.
8. After installing the beam bearing cap, measure
the end play of the crankshaft. If the end play
exceeds the limit, replace the crankshaft
bearings.
Standard value: 0.05 − 0.25 mm
Limit: 0.4 mm
ENGINE OVERHAUL <4G63-Turbo>
CRANKSHAFT AND CYLINDER BLOCK
>>E<< REAR OIL SEAL INSTALLATION
Use the special tools to press-fit the rear oil seal in
the rear oil seal case.
• Handle (MB990938)
• Crankshaft rear oil seal installer (MD998776)
>>F<< REAR OIL SEAL CASE
INSTALLATION
1. Remove completely old FIPG remaining on the
AK300201
2. Apply a bead of FIPG to the surface of the rear oil
rear oil seal case and cylinder block.
seal case as shown in the drawing.
Specified sealant:
11D-65
MB990938
MD998776
AK300202 AD
AK300576AD