Mitsubishi 4g63 Service Manual page 23

2. Install the auto-tensioner in position. Leave the
wire installed until the auto-tensioner is
completely installed.
>>L<< TENSIONER PULLEY
INSTALLATION
Tensioner
pulley hole
Install the tensioner pulley with its holes aligned as
shown in the drawing.
>>M<< TIMING BELT INSTALLATION
Timing marks
1. Bring the timing mark on the exhaust camshaft
sprocket to a point one sprocket tooth away from
the timing mark on the rocker cover in the
counterclockwise direction.
ENGINE OVERHAUL <4G63-Turbo>
TIMING BELT
AK300154
2. Align the timing mark on the intake camshaft
AK300147 AE
3. Bring the timing mark on the crankshaft sprocket
AK304440AB
4. Align the timing mark on the oil pump sprocket
NOTE: If the timing marks were aligned, the
exhaust camshaft would be turned
counterclockwise by one sprocket tooth and stay
there by the force of the valve springs.
Timing marks
sprocket with that on the rocker cover.
NOTE: The intake camshaft will be turned slightly
clockwise from where the timing marks are
aligned by the force of the valve springs and stay
there.
Timing marks
to a point one sprocket tooth away from the
mating timing mark in the counterclockwise
direction like in the operation with the exhaust
camshaft sprocket.
60 mm or more
Counter
balance
shaft
with that on the cylinder block.
(1) Remove the plug from the cylinder block.
11D-23
AK304441AB
AK304563AB
AD
AK301077