Audiovox Prestige P-953ESP Owner's Manual page 8

dl dl dl dl dl
PRE-SET SCAN (PS) /AUTO-STORE TUNING (AS)
Press this button momentarily to scan the stations pre-set into the
AM band, or the six memories of each FM band. The unit will stop
at each pre-set station for 5 seconds before continuing to the next
pre-set station (the pre-set number on the display panel will flash
during Pre-Set Scan operation). Press the button again momentarily
to stop Pre-Set Scan operation and remain on the selected
frequency.
Pressing and holding the button for longer than 2 seconds will
activate the Auto-Store Tuning feature which will automatically scan
and enter up to 6 stations into the pre-set memories of each FM
band and the AM band. If you have already set the pre-set memories
to your favorite stations, activating the Auto-Store Tuning feature
will erase those stations and enter the new ones. This feature is
most useful when traveling in a new area where you are not familiar
with the local stations.
dm dm dm dm dm
THEFT-DETERRENT LED
Located on the chassis behind the front panel, a light-emitting diode
(LED) will flash when the panel is physically removed. The flashing
light serves as a visual warning to the would-be thief that the unit has
been disabled by removal of the front panel.
dn dn dn dn dn
RESET BUTTON
The RESET button is located to the right of the theft deterrent LED.
The reset circuitry should only be activated under the following
circumstances as it will erase the time and pre-set memories:
1. Upon initial installation after all wiring is completed.
2. If there is a malfunction of any of the switches on the unit,
pressing the RESET button may clear the system and return
to normal operation.
do do do do do
FRONT PANEL RELEASE BUTTON (OPEN)
This button is used to release the mechanism that holds the front
panel to the chassis. To detach the front panel, press the button so
that the panel drops to the lowered position. Grasp the panel at the
middle and pull it off of the chassis. To re-attach the panel, press it
straight onto the chassis until the mechanism locks it into place.
dp dp dp dp dp
REMOTE SENSOR
The sensor to detect the infrared signal from the wireless remote
control is located behind the VFD display lens. For optimum
operation of the remote control, always aim the control at the VFD
display.
NOTES ON USE OF FRONT PANEL
1. Make sure the front panel is positioned correctly when slid-
ing it into the front mounting plate, as it cannot be attached
when up-side down. Use moderate pressure to fully seat
the panel into position.
2. To verify correct panel installation, swing the panel as -
sembly up into position until it locks easily into place. If
any resistance is encountered, re-check panel orienta -
tion in chassis mounting plate.
3. When taking the front panel with you, please use the sup -
plied carrying case to protect the panel from dirt and
damage. Make sure there is no dust or dirt on the
electrical terminals on the back of the panel as this could
cause intermittent operation or other malfunctions.
-8-
128-6880
8 of 20