Table of Contents
Advertisement
Changing the P-touch Settings
Tube Settings Tab
1 Cut Mark Type
Specifies the mark printed on tubes to indicate the tube cutting position.
Available settings: [None], [Dot], [Line]
2 Cut Depth
Adjusts the depth of half cuts.
Available settings: -3 to +3 (1 increments)
3 Full Cut
Adjusts the full cutting power.
Available settings: [Normal], [Strong]
4 Print Speed
Adjusts the printing speed.
Available settings: [Faster Speed], [Better Quality]
Note
• The [Better Quality] mode can improve the print result when printed characters are faint.
• If you use the P-touch in an environment with a temperature of 20°C or lower, we recommend setting [Print
Speed] to [Better Quality].
5 Print Density
Adjusts the printing density.
Available settings: -3 to +3 (1 increments)
6 Feeding Pressure
Adjusts the feeding pressure to make the print result fainter or darker.
Available settings: [Normal], [Strong], [Soft]
7 Adjust Length
Adjusts the length of the printed tube to correspond to the length of the tube displayed on the computer.
1
2
3
4
5
6
7
8
9
10
11
3
3
25
Advertisement
Table of Contents
